The second tab on the Data Tables Configuration interface, Required Items, allows the user to specify the location of the source data for routes and sample data. In order to accomplish this goal, the user can select the desired Data Table in the top left picklist on the interface. This tab also possesses its own internal tabs-- Routes and Sample Section Locations-- to enter the appropriate information.

Routes Tab

Users can utilize the Routes tab to enter in the source of the route network. There are two options for sources here: R&H and Non-R&H. 

R&H Source

To add a R&H route source, the user must follow these steps.

(1) Check the “Is R&H” checkbox at the top left of the interface, under the internal tabs. The fields will then change to support R&H route sources.

(2) Fill out the Map Service, Network Name, Version, and Filters fields.

(3) After filling in the desired fields, click the “Save Changes” button at the bottom of the interface.

Non-R&H Source

To add a Non-R&H route source, the user must follow these steps.

(1) Uncheck the “Is R&H” checkbox at the top left of the interface, under the internal tabs. The fields will then change to support Non-R&H route sources.

(2) Fill out the Data Source Dropdown, Table Name, Route ID, From Measure, To Measure, From Date, To Date, and Filters fields.

(3) After filling in the desired fields, click the “Save Changes” button at the bottom of the interface.

Sample Section Locations Tab

The Sample Section Tab can be used to specify the source data for samples. Similar to the Routes tab, the fields on this tab change based on the R&H or Non-R&H status.

R&H Source

To add a R&H sample source, the user must follow these steps. 

(1) Check the “Is R&H” checkbox at the top left of the interface, under the internal tabs. The fields will then change to support a R&H registered event. 

(2) Fill out the Map Service, Version, Event Name, Source, HPMS Data Table, and Filters fields.

(3) After filling in the desired fields, click the “Save Changes” button at the bottom of the interface.

Non-R&H Source

To add a Non-R&H sample source, the user must follow these steps. 

(1) Uncheck the “Is R&H” checkbox at the top left of the interface, under the internal tabs. The fields will change to support a Non-R&H event.

(2) Fill out the Data Source, Table Name, Column, Route ID, From Measure, To Measure, From Date, To Date, and Filters fields. The user can select the Allow Save to Source checkbox if desired.

(3) After filling in the desired fields, click the “Save Changes” button at the bottom of the interface.

User Guide

For more general information on this tab, visit the User Guide equivalent article on the Required Items tab.