Refresh Data Table

Once the user has configured all the routes, samples, and desired HPMS data items, they can populate the data table by clicking the “Populate Data Table” button found on the Data Table Information, Required Items, or Attributes tab. These tabs are located under the Data Tables Configuration icon on the System Administration ribbon. After the populate process is complete, the button will change to display the message, “Refresh Data Table.”

At any point, the user can reload the data in the table with the latest updates by clicking the “Refresh Data Table” button. This population process only adds data items that are complete (i.e., all required fields have values on the data table). The “Attributes Complete Message/Count” will appear below the Attributes tab's table to display the number of data items that are complete, and it will appear in the data table after the populate/refresh process.

In the image below, the Refresh Data Table button and the Attributes Complete Message/Count are indicated in red boxes to show their position and format on the interface.

Status Icons

After populating the data table, the user should check the Required Items and Attributes tabs to see if an error occurred during the populate process. On the Required Items tab, an icon will appear in the tab header. On the Attributes tab, an icon will appear in the “Status” column (shown above). The three statuses and their icons are described here.